SM-CSM503 13 cm 3-way coaxial acoustic system Instruction manual 13 3-
Description The set of acoustic system includes: - acoustic system - metal grill – 2 pcs - speaker wire – 3 m - screw – 8 pcs - clip – 8 pcs 2m (x 8) (x 8) Important safeguards The owner’s manual contains important operating and maintenance instructions for your safety. It is necessary to refer the manual. Do not install the speakers where they may be subjected to excessive heat, moisture, dust or where they will be kicked repeatedly, brushed or bumped.
Make absolutely sure that the terminals for the speakers are connected to the proper outputs from the music source. Never run the wiring on the outside of the vehicle or under it where it can be damaged by road hazards or the moving parts of the vehicle. Use existing wire channels, sills, panels and molding strips inside the vehicle to hide the wiring for safety and a neat appliance. Make sure the wire of the negative pole terminal is disconnected from accumulator while connecting the speaker terminals.
If it will be necessary to cut steel, reinstall the cosmetic panel in place and use the hole you have previously cut as a template. This will help you ensure proper cutting and a good fit. Now, mark the locations for the speakers mounting screws, remove the panel and drill the screw holes. When finished, you may replace the panel. After cutting and drilling all holes, inspect the mounting areas for any metal burrs or rough edges. File any area that may interfere with the mounting of the speaker.
Turn your system on and confirm the speakers operation first at a low volume and then you may increase the volume as you desire. After installation of the acoustic system and having tested it the speaker grill will have to be inserted. Turn on you system and follow these steps carefully: - locate the speaker grill; - now carefully inspect the place where the speaker grill will be mounted – there should be no blowholes; - fix the speaker grill with screws.
If unit fails to operate properly Carefully read the instruction to make sure the unit is being operated properly. Check the following before you take your unit to the local dealer for repair.
Specification Loudspeaker one Magnet woofer: midrange: tweeter: main: midrange: tweeter: 13 cm carbon compound kevlar woven cone 30 mm mylar 15 mm piezo ferrite 13 Oz ferrite ferrite Peak output power 140 W Rated output power 70 W Impedance 4 Sensitivity 91 dB Frequency response 60 Hz– 20 kHz Dimensions 155.5 x 71 mm Net/Gross weight 0.8 kg / 1.
: - 2 (x 8) 8 ( 8) –2 . –3 –8 . –8 .
. . , , , , . , (-) . . , ( , ) . , . , . , , , . , (-) . , . , . , , . . : , . .
. , , . . . . . , , ( ). ( =112 , Ø =5 , ). , : ; - ; ; . . , , , . , .
, . , . , . , . . . - : ; ; .
, , . , .
: 13 : 30 : 15 : 13 (368,5 ) : : 140 70 4 91 60 – 20 155,5 x 71 0,8 ( x x ) 308 13 / 1,7 173 96
