Instruction Manual

1.800.338.7337 / www.soundoffsignal.com
ETSA46(x)HPP 11.13
400 SERIES REMOTE AMPLIFIER SIREN
W/ HANDHELD REMOTE
ETSA461HPP - 100W
ETSA462HPP - 200W
Please see page 3 for
Technical Specifications
Microphone,
Lights and Siren
Controller
Amplifier Box
Introduction
IMPORTANT NOTICE TO INSTALLER:
Make sure to read and understand all
instructions and warnings before proceeding
with the installation of this product. Ensure
the manual and all warning cards are
delivered to the end user of this equipment.
!
WARNING
Sirens produce loud sounds that
may damage hearing:
- Roll up windows.
- Wear hearing protection.
- Use only for emergency response.
- Avoid exposure to siren sound
outside of vehicle.
PSRN4ANR1 100W
PSRN4ANR2 200W
Package Contents:
1 ea. Amplifier Box
1 ea. Handheld Controller
1 ea. Cradle with Mounting Hardware
5 ea. Amplifier Wire Harnesses with Connectors (1-4
pin, 1-12 pin, 1-5 pin, 1-14 pin and 1-8 pin)
1 ea. Instruction Manual
1 ea. Operators Warning Card to remain in vehicle for
operator review
1 ea. Sound Pressure Warning Label that is to be
attached in vehicle and in plain site of operator
and occupants of the vehicle
1 ea. Label Card for Aux. Switches
1 ea. Harness Coupler
HANDHELD SIREN CONTROLLER
PSRNHHC1
1
The ETSA46(x)HPP is a remote mounted siren
amplifier designed for a single (ETSA461) or
dual (ETSA462) external speaker.
The amplifier box is controlled with a hand
held remote containing a noise-cancelling
microphone for PA use. The ETSA462 contains
a 2 channel amplifier for driving 2 independent
sounds. The ETSA461 is a single 100w design.
The controller offers 3 multiple programmable
levels as well as 8 independently controlled
accessory switches.
Notice
Sirens provide an essential function of an
effective audio / visual warning system.
However, sirens are only short range secondary
devices. The use of a siren does not insure that
all drivers can or will abide by or react to an
emergency warning signal, especially at high
rates of speeds or long distances. The operator
of the vehicle must never take the right of way
for granted and it is the operator’s responsibility
to proceed safely.
The effectiveness of this siren system is
highly dependant on the correct mounting
and wiring. The installer must read and follow
the manufacturer’s installation instructions
and warnings in the manual. The vehicle
operator should verify the siren system is
securely fastened to the vehicle and properly
functioning.
Effective sirens generate loud sound pressure
levels that can potentially cause hearing
damage. Installers and those around the vehicle
need to be aware of the dangers and wear
hearing protection whenever the siren system
is operating. Vehicle operators and occupants
should assess their exposure to siren noise
and determine what steps need to be taken to
prevent hearing damage.
The siren system is intended for use by
authorized personnel only. It is the user’s
responsibility to ensure they understand and
operate the emergency warning devices in
compliance with all applicable city, state, and
federal laws and regulations. SoundOff
Signal assumes no liability for any loss resulting
from the use of the siren system.