User Manual

20
ENGLISH
REALKIT-touch User manual
Reverb Type: Select reverb type for reverb effect con-
trolled by S1.
F X S E T
R e v e r b T y p e R O O M 1
Dist.Pst: Select distortion type. Select OFF to disable
distortion. Distortion effect can only be selected here.
Threshold: Select the threshold for Compressor/Lim-
iter controlled by S2. Decrease this value by certain
amount may avoid clipping.
LowFrq: Set low frequency point, which is controlled
by S3. Shelf type, the value is at the middle position on
slope.
LoMiFrq: Set low mid frequency point, which is controlled by S4. Bell type, the value
is at the center of bell curve.
HiMiFrq: Set high mid frequency point, which is controlled by S5. Bell type, the
value is at the center of bell curve.
HighFrq: Set high frequency point, which is controlled by S6. Shelf type, the value
is at the middle position on slope.
Note: In some cases, the value of the fader is not match to its actual posi-
tion. For situation like this, the fader will be activated until its actual position
has reached is value shown on screen.
MIDI SET
Assign controller and channel for each fader in MIDI
mode. You can either slide the fader or use PAGE DOWN/
UP to switch between options.
S L I D E R 3 M I D I
C h a n n e l 3
S E T U P
M I D I S E T = = >
S L I D E R 3 M I D I
C o n t r o l l e r 1 3
ADVANCED SETTINGS
Includes all the physical settings for pads/triggers.
S E T U P
A D V A N C E = = >