User Manual

21
ENGLISH
REALKIT-touch User manual
Sensitivity: The higher the value is, the easier it will
be to trigger. But if this value is too high, will cause
some crosstalk problems.
T O M 1 A D V
S e n s i t i v i t y 7 7
Headroom: Set the velocity dynamic range. This val-
ue is the velocity needed to get max volume, so the
lower the value is, the easier to get louder sounds.
T O M 1 A D V
H e a d r o o m 8 7
TIPS: You can use the faders to adjust the volume quickly, but it will not be
saved if you power off the sound module.
The concept of Headroom is essentially different from Volume. Headroom
decides the velocity to reach the max volume, but cannot change the max
level of volume.
SenseTime: Sets the interval between two triggering.
Increase this value by certain amount may avoid being
triggered multiple times by vibration in very short time.
T O M 1 A D V
S e n s e T i m e 5 0
Trigger: Sets the velocity curve for pads, including
Linear, EXP1&2, LOG1&2 and Spline. On horizontal
is the velocity you strike, and on vertical is the volume
after processed by the trigger curve.
T O M 1 A D V
T r i g g e r L i n e a r
Vo l- ume Vo l- ume
Vo l- ume
Vo l- ume
Linear Exp Log Spline
Strength
Strength
Strength
Strength
Diagram of 4 types of the curve
Xtalk: Sets the crosstalk for pads. Use max power to
strike a pad repeatedly until the screen shows OK, and
then change to another pad and repeat the procedure.
Velocity data on other pads will be loaded automatical-
ly for reference in order to avoid crosstalk.
T O M 1 A D V
H e a d r o o m A u t o
Note Send: Set the MIDI note for each trigger. When
the MIDI note is different between this module and
other sound sources, by adjusting this value they can
be easily matched.
T O M 1 A D V
N o t e S e n d 4 8
Rim Velocity: Rim velocity correction option will ap-
pear when you strike on the rim or edge parts. The
higher the value is, the louder it will become. Cymbal
edges are also included in this setting.
T O M 1 -R i m A D V
Ri m V e l oc i ty 5 0