User Manual

6. Press and hold Program & TAP SYNC/DISPLAY buttons to exit and save set-
ting. All LEDs will blink.
NOTE: All wheels can be re-assigned to output on different DMX channels.
You can re-assign Pan / Tilt channel to all controller fader channels.
5.4. Resetting the System
Warning: This will reset the controller to its factory defaults. This will erase all programs
and settings.
1. Turn off the unit.
2. Press and hold BANK UP and AUTO/DEL.
3. Turn on power (while still holding BANK UP and AUTO/DEL).
5.5. Copy Scanner
Example: Copying Scanner 1 into Scanner 2
1. Press and hold SCANNER button 1.
2. While holding button 1 press scanner button 2.
3. Release SCANNER button 1 rst before releasing SCANNER button 2 and LED
indicator of SCANNER 2 will ON.
4. The target SCANNER LED indicators will ash to conrm successful copy.
NOTE: To save time, you can copy the settings of one Scanner button to an-
other.
5.6. Fade Time Assign
You can choose whether fade time during scene execution is implemented broadly
to all output channels, or only to the Pan & Tilt movement channels. This is relevant
because often you will want gobos and colors to change quickly while not affecting the
movement of the light.
1. Turn OFF the controller
2. Hold the BLACKOUT and TAP SYNC/DISPLAY buttons simultaneously.
3. Turn on the controller.
4. Press the TAP SYNC/DISPLAY button to toggle between the two modes. Either
12
ENGLISH
SCENEMAKER 1216 User manual