User Manual

10. TROUBLESHOOTING
Phenomenon Solution
Fixture cannot start to work 1. Check if the power fuse burnout
Fixture light normally, but no re-
sponding to the DMX controller
1. Check if the DMX start address is correct
2. Check if the XLR signal cable was damaged
Fixture work intermittently
Check if the fan work well, Whether dust blocked
fan and fan nets
Dark light, brightness decreases
obviously
Check whether the internal and external optical
system is clean
Beam is not pure (have a halo)
Clean the dust and oil of bulb, lens and other
parts
Beam is seriously distorted
1. Check whether the lens is broken
2. Clean the dust or oil of lens
11. Maintenance
When the lens have fracture and other damage, it should be replaced in time. When the
xture can’t start to run, please check if the fuse is burnout. If it is so, please install the
tted corresponding specication fuse (5x20mm T5A / 250V).
The TWILIGHT 180 BEAM is installed with overheating protection device, when it is
overheat, the overheating protection device will automatically cut off power supply.
Please check whether the fan is running, whether the fan and fan nets have dust jam,
nd troubleshooting before working. But note that a qualied technicians can do the
repair work.
In order to maintain the gobo wheel smooth rotation and smooth movement, it is sug-
gested to add grease for the rotation gobo wheel every two months. Should use good
quality grease.
In order to ensure the xture working well, maintain the cleanness of xture is very
necessary. It should be clean once every 30 days after cooling the fans. Internal and
external optical lens, reector and coating color lter cleaning must be carried out
periodically to optimize the output light efciency. Do not use any contains chemical
solvent cleaning coating color lter. Cleaning the xture depending on the operating
frequency of xture and the surrounding environment. Clean with a soft cloth and
cleaning products for glass, suggest to clean the external optical system at least once
every 30 days , clean the internal optical system at least once every 30/60 days. Please
do not use alcohol and other organic solvents to wipe housing, lest cause damage.
12. SPECIFICATIONS
Light emitting source Ultra-bright 180W LED
16
ENGLISH
TWILIGHT 180 BEAM User manual