User Manual

6. A-Enter Button: It access to all editing functions of A-System (See section "8. SYS-
TEM SETUP" at page 11 for further details).
7. A-DOWN Button: During System-A editing, it decreases current parameter’s value.
8. A-IR Button: Press it to synchronize the operating channel between receiver and
A-transmitter.
9. IR Sensor: It is the infrared sensor used to synchronize the operating channel
between receiver and the two transmitters (both A and B Systems).
10. B-UP Button: During System-B editing, it increases current parameter’s value.
11. B-LOCK: It locks/unlocks B-system in order to avoid accidental setup parameters
changes.
12. B-IR Button: Press it to synchronize the operating channel between receiver and
B-transmitter.
13. B-DOWN Button: During System-B editing, it decreases current parameter’s value.
14. B-Enter Button: It access to all editing functions of B-System (See section "8. SYS-
TEM SETUP" at page 11 for further details).
15. B-Volume: It adjusts B-system audio output level.
16. B-System TFT Color Display: It shows all functions and allows easy and intuitive
programming of all parameters.
17. A-Antenna: It receives RF signals from transmitters. It’s important to always plug
the two supplied antennas to their connectors on rear panel, taking care to screw
them all the way, and ensure maximum receiving capacity of the system.
18. B-Antenna: Same as Antenna-A.
19. Mix Output: It is the channel-A + channel-B unbalanced audio line output with ¼”
Jack to use in case of connection to mixers or audio equipment with unbalanced
connections.
20. Unbalanced Output B: It is the System-B unbalanced audio line output with ¼”
Jack to connect to your mixer or audio system. For more details about the internal
wiring of balanced cables, refer to paragraph "11. AUDIO CONNECTIONS" at page
18.
21. Unbalanced Output A: Same as unbalanced output B but for System-A.
22. Balanced Output B: It is the Channel-B balanced XLR audio line output to connect
to your mixer or audio system. For more details about the internal wiring of bal-
anced cables, refer to paragraph "11. AUDIO CONNECTIONS" at page 18.
9
ENGLISH
WF-U2600 User manual