User Manual

Table Of Contents

f Turn on the receiver by pressing POWER button (1). LCD (6) will light up showing

current settings of the system.

8. SYSTEM SETUP

Please notice that when you switch the receiver on LOCK function ( ) is active on both

Channels. Hold for a few seconds SET button A (4) or SET button B (7) to unlock and

have access to parameters. icon will turn off.

NOTE: In addition to the active LOCK function, at power on the receiver is

even muted ( icon ashes in the display) until you turn on the transmitter

and align it on the same receiver’s channel.

8.1. Channel Setup Mode

MHz

iR iR

FREQ UE NC Y

CHAN NE L

FREQ UE NC Y

CHAN NE L

VOL

POW

VOL POW

VOL

After unlocking the receiver, icon will turn off and the

CHANNEL

icon ashes, indicating

that you can choose one of the 300 available channels.

f Press UP or DOWN buttons to increase or decrease channel number and its associ-

ated frequency.

f Once you have located an interference-free channel, press and hold for about 2

seconds SET key to switch to ACT mode and transmit the selected channel to the

transmitter.

NOTE: If during channel selection you do not press any button for about 10

seconds, the system automatically returns to mode. It is therefore neces-

sary to unlock the receiver again to re-access channel setup mode.

8.2. Auto Search Mode

SOUNDSATION WF-U2300 is equipped with a useful automatic frequency scan func-

tion. This allows you to always choose those channels with less problems and make

setting operations extremely quick.

f To automatically perform a frequency scan, unlock - if not already done - the receiver

by holding for a few seconds SET button ( icon disappears).

f Then briey press SET button again to enter auto search mode. The display shows

the following screen:

ENGLISH

WF-U2300 User manual