User Manual

2. Once you have made a selection then press ENTER to con-
rm.
3. Use DOWN and UP button to choose the desired menu op-
tion.
4. Just wait 20 seconds, the menu structure is shown in previous
page.
This product has a memory function. It will go directly into DMX mode after switching
on, it will show “A001”. Once a menu has been selected the next time it is powered on
the unit will show the mode you previously nished on.
6.2. Footswitch
The footswitch has 2 pedals
f Left pedal is blackout / on. Pressing the left pedal once will blackout the unit and all
par cans will go off
f Pressing the left pedal once again the unit will light and return to be the position the
unit was in before black out was pressed. In blackout mode the display will show OFF.
Using the right hand foot pedal (programs) APon.
f By pressing the program pedal the kit will step through the built in options.
f Auto programs 1-12 and Auto programs ALL. The digital display will read “APon ->
Ap01 -> AP02 -> AP03 -> Ap04-> AP05 -> AP06 ->AP07-> AP08 -> AP09 -> AP10
-> AP11 -> AP12 -> ALL”) as you step through the selection.
f You also can step on the “PROGRAMS” footplate again to select into R ->G ->B ->RG
->GB ->RB -> RGB -> modes.
7. MODE INTRODUCTION
DMX512 mode
To receive DMX512 controller and the slave data.
Auto mode
There are 12 modes under this the auto mode: from AP01 to AP12. On every mode you
can set running speed.
Manual mode
Direct RGB control of color and strobe speed can be manually set under this mode.
f When display shows r-00 - r08, you can increase RED brightness value.
f When the display shows g-00 - g08, you can increase GREEN brightness value.
f When the display shows b-00 - b08, you can increase BLUE brightness value
10
ENGLISH
4LEDKIT-PARTY User manual