User Manual

10
ENGLISH
hyper BASS series User manual
2) IEC Socket with Fuse holder
Plug the line cord into an AC socket properly congured for your particular model. In
case of fuse burn, to prevent the risk of re and damaging the unit, please use only
of the recommended fuse type as described in the manual. Before replacing the fuse,
make sure the unit turned o and disconnected from the AC outlet.
Note: If you happen to lose the AC line cord, always use a three-pin plug with
a ground pin.
3) Stereo Balanced LINE Inputs
This pair of female XLR-type connectors accept a balanced line-level signal. Connect
these inputs to your mixer; do not connect dynamic or condenser microphones.
4) Link Outputs
This is a pair male XLR-type connectors that route stereo input signals without aecting
to the audio content. It is used to link the unit to another speaker or subwoofer.
5) X-OVER
This switch toggles between 80Hz and 120Hz crossover frequency. It has to be set
depending on speakers used for reproduction of mid-high frequencies. For speakers
with 12” woofers or lower, it is normally set to 120Hz position; while in case of 15” it is
normally set to 80Hz.
6) Outputs
This is a pair male XLR-type connectors containing ltered stereo signals. Connect them
to a pair of full-range active speakers of a power amplier in order to amplify the mid-
high part of frequency range.
7) Power and clip indicators
When POWER switch is turned on, and line cord is connected to an active AC Mains
supply, this POWER indicator is lit.
CLIP LED lights up only when the input signal is too high and limiter operates in order
to prevent unwanted damage to amplier or transducers.
NOTE: To better adjust levels and avoid limiter to intervene and cut signals,
once connected the desired sound source slowly turn up MIC/LINE or LINE
LEVEL controls until the desired volume is reached (and the CLIP light comes
on occasionally). Always protect your hears if you are close when it is playing
at high levels.
8) Phase
This two-position switch turns the audio signal reproduced by the subwoofer by 180°.
Phase rotation helps the optimization of low frequency reproduction even under the
most dicult installation situations. After completing the installation, play a known
track and press the button to get the best bass reproduction.