Wireless Subwoofer Volume Control System OWNERS MANUAL AND INSTALLATION GUIDE

4
INTRODUCTION
The AIRBASS wireless subwoofer control allows you to grasp total
control over your subwoofers. A hand-held wireless transmitter
(programmable to run multiple Soundstream amplifiers) controls up to
24 dB of volume, allowing you to custom tailor the amount of bass.
And for those of you who like to jump to extremes, press the
MAXIMUM BASS button and prepare to be blown away!
DESIGN FEATURES
• Wireless Control - No cables necessary! Control the bass level
from outside of your car.
• Eight Step Precision Resistor Volume Control - Controls the
output level of the amplifier, up to 24 dB of range!
• Four-function Controller - Allows volume level up, volume level
down, mute and Maximum Bass adjustment.
• Simultaneous Multiple Amplifier Control - Any number of
AIRBASS receiver boards can be programmed to be controlled by
one transmitter.
• Multiple Car Control - Each transmitter contains codes to control up
to four cars.
• EncryptoMorphic™ Transmitter Coding - Each transmitter has a
unique algorithm for security code calibrations, so that transmitter
code copying will be impossible. Over 4 billion code combinations
are possible with this technology!
• Gold Plated Contact Points - The push-button contact points and
the battery terminals inside the hand-held transmitter are gold plated
to prevent corrosion and to ensure reliable operation.
• AIRBASS is the recipient of the
prestigious Autosound Grand Prix
Technology Award.
9
MULTIPLE CAR INSTALLATIONS
For installations using one transmitter to control AIRBASS receiver
boards in multiple cars, each transmitter has four "banks" of codes.
Any receiver board can be programmed to learn ONE bank of codes.
Therefore, any transmitter can control up to four different subwoofer
amplifiers independently!
BUTTON BANK NUMBER
é
1
ê
2
M
3
X
4
Each AIRBASS unit is shipped pre-programmed to accept codes from
bank #1. To program a receiver board to accept codes from another
bank, please follow these steps:
1. On the AIRBASS transmitter, press the SHIFT KEY (button #2 in
the diagram on page 5). The LED will light STEADY GREEN and
RED at the same time.
2. While the LED is STEADY GREEN / RED, press the button
corresponding to the bank which you want the AIRBASS receiver
board to be programmed to. The LED will then FLASH GREEN the
number of times representing the bank it was set to (ONE FLASH
for bank #1, TWO FLASHES for bank #2, etc.) Then the LED will
light STEADY RED for about a second, and then go out.
3. The transmitter has now been set to a new bank of codes. To
program the AIRBASS receiver board to accept this new bank of
codes, follow the steps on the previous page for receiver board
programming.
NOTE: The hand-held transmitter will stay in whatever bank you
switch it to. It does not automatically revert back to a previous bank of