2 Ohm Nominal Component Speaker System OWNER’S MANUAL 1 60.
SPL 60 Component Speaker System Congratulations on your purchase of the Soundstream SPL 60 Component Speaker System. When used with a high quality 2 ohm rated power amplifier, the SPL 60 will provide exceptional performance. As with all high quality car audio components, professional installation is recommended. Your dealer’s knowledge and experience can ensure a problem-free, cosmetically integrated installation.
FEATURES SPL 6 Midrange / Woofer The SPL 6 is an excellent performer with a combination of high sensitivity, solid bass and smooth response throughout the audible range. • Lightweight Cone designed for good rigidity and high sensitivity • 2 Ohm Voice Coil for increased output SPL 1 Aluminum Dome Neodymium Tweeter The SPL 1 tweeter is a high performance 1” Neodymium tweeter designed to deliver outstanding high frequency reproduction.
LOCATION AND MOUNTING The first step in a successful installation is thorough planning. Choose the location for your speaker components carefully. Follow these suggestions to ensure proper imaging and the best performance: • Select a location where each tweeter and midrange/woofer can be mounted close to each other. A good rule of thumb is a maximum of one foot from cone to tweeter. • Choose a location that offers obstruction of sound to your ears.
1 /4” 6-32 machine screw Turn Clockwise to Lock Flush mount cup Mounting surface FIGURE 1 Spring clip FIGURE 2 Surface Mounting: 1) Drill one 5/16" diameter hole for the tweeter lead wires and two pilot holes for the mounting screws. 2) Attach the surface mount plate with two flat head screws. 3) Pass the lead wires through the hole. See figure 3. 4) Engage the locking holes on the back of the tweeter onto the tabs on the plate and rotate counter-clockwise until locked. See figure 4.
INSTALLING THE SPL 6 MIDRANGE/ WOOFER The SPL 6 Midrange/Woofer can be mounted on the front or rear of a panel; gaskets are provided for both options. The bolt hole configuration will fit a variety of American, European and Asian OEM patterns making it ideal for direct placement. Best performance is achieved when the speaker is securely mounted to a door panel or rear deck. There should be no gaps between the speaker and the mounting surface, as this will impair its low frequency performance.
TWEETER Tweeter Attenuation SPL 60 system has been designed to provide LEVEL The optimum sound in a variety of installation locations. The CONTROL provided crossover allows for 2 positions of tweeter level control, 0dB and -3dB. A switch under the plastic crossover cover sets one of the two positions. The factory setting is 0 dB. Tweeter Level Control Switch FIGURE 5 WIRING SPL 6 Wiring Diagram Figure 6 shows a diagram illustrating the wiring of the SPL 60 Component Speaker System.
SPECIFICATIONS SPL 60 System Specifications Frequency Response 55 Hz - 20,000 Hz ±3dB Sensitivity 94 dB SPL at 1 meter (2.83 Volts) 100 dB SPL at .5 meter (2.
