Owner's Manual

Remote
This terminal must be connected to a switched + 12V source. Typically, remote turn-on
leads are provided at the source unit that will turn on and
off
the amplifier in
correspondence with the source.
If
the source unit does not have a remote turn-on lead, then
a power antenna wire can be used.
If
neither
of
these leads is available at the source unit,
then a switched+ 12V supply must be used, like the ACC, + 12V.
Run a minimum
of
18
gauge wire from the amplifier location to the source
of
the switched
+ 12V lead.
If
possible, route this wire
on
the same side
of
the vehicle as your power cable.
Connect the source remote output to the wire. Go back to the amplifier and cut the wire to
length. Loosen the screw terminal marked REMOTE on the amplifier using a
Philips
(cross)
type screwdriver. Insert the stripped (bare) portion
of
the wire into the terminal and tighten
the screw securely.
13