Owner's Manual

1.
LINE IN (RCA) Jacks
The RCA style input jacks are for use with source units that have
RCA
line level
outputs. A source unit with a minimum
of
250m
V
is required for proper operation.
However, this input will accept levels up to 6Vrms.
2. High Level Input
If
you are installing by using a high level. you do not need to connect to the remote because.
To
hear a better sound quality, you must connect the high level ground wire
to
the head-unit
ground.
3. GAIN Control
This control is used to match the input sensitivity
of
the amplifier to the particular
source unit that you are using.
4. HPF (High Pass Filter) Control
This control is continuously adjustable from 35Hz through
250Hz
at 12dB per octave
5. Bluetooth Indicator
The white LED when the your mobile phone and pairing is on.
6.
POWER
Indicator
The GREEN when the power is on.
7. Protection Indicator
The amplifier protection circuitry will disable the amplifier
If
Input overload, short circuit
or extremely high temperature conditions are detected. When the protection mode is in
operation, the LED indicator on the side panel will be illuminated. Indicating the amplifier
has gone into a self-preservation mode.
If
you observe that protection LED is
It,
please check the system carefully
to
determine what
has caused the protection circuit
to
engage. The amplifier can be reset by turning the remote
power off and then on again.
If
the amplifier shut down due to a thermal overload
of
an input
overload or short circuit, be sure
to
repair these conditions before attempting to power
up
the
amplifier again.
8. SPEAKER Terminals
As shown in the wiring diagrams,
be
sure to observe speaker polarity through the
system and speaker impedance. This specially tooled terminal is designed to
accommodate up to 1
0
gauge speaker wire.
9. GND (Ground Input Connection)
A good quality ground is required for your
MICRO
MINI
amplifier to operate at peak
performance. A short length
of
cable the same gauge as your power cable should be
used to attache the ground terminal directly to the chassis
of
the vehicle.
7