Owner's Manual

10. REMOTE
(Remote Input Connection)
All
MICRO
MINI
amplifiers can be turned on by applying
12
volts to this terminal. This can
be
found
on
the rear
of
the source unit in the form
of
an
electric antenna output,
or
a
remote output.
If
this is not available you can wire
to
the
ACC
position
on
the key.
An
18 gauge wire is sufficient to run the
REMOTE.
11.
REMOTE
(Remote out Connection)
You
can use when tum on another amplifier
You
should be careful when connecting remote in and remote out wire.
12.
+BATT
(Power Input Connection)
This terminal is the main
power
input for the amplifier and
must
be
connected directly
to the positive
(+)
terminal
of
the
car
battery. (see
Power
Cable Selection Chart
on
Page
9 for recommended wire gauge for each model).
13.
FUSE
For convenience all
MICRO
MINI
amplifiers utilize common automotive ATC type fuses.
For continued protection
in
the event that a fuse blows, replace the fuse only with the
same value (see specifications page).
14. Omni
Antena
When connected, the longer the communication distance.
Please
use solidly fixed
it.
15. Thru-Pass
Out
These inputs are signal cables from the source.
Always use high quality shieded RCA cables.
The Thru-pass allows you to build mulitiple amplifier systems without having to use splitter
cords to distribute that the signal.
Now it is simpli a matter
of
bring one set
of
RCAS
into the first amplifier, tnen using the line
out RCA jacks
as
the feed to the next amplifier.
8