Owners Manual

WIRING CONNECTIONS

Make sure you have good chassis ground. A good ground connection will eliminate most

electrical noise problems. A good chassis ground requires a tight connection to the vehicle’s

metal chassis. The area around the ground connection should be clean, bare metal without rust,

paint, plastic, dust, or dirt for a good electrical connection.

Caution: Do not interchange the

connection of the wiring!!!

For some car models you may need to

modify wiring of the supplied power

cord. Contact your authorized car

dealer before installing this unit.

Using the ISO Connector

1. If your car is equipped with the ISO

connector, then connect the ISO

connectors as illustrated.

2. For connections without the ISO

connectors, check the wiring in the

vehicle carefully before connecting,

incorrect connection may cause serious

damage to this unit.

3. Cut the connector; connect the

colored leads of the power cord to the

car battery as shown in the color code

table below for speaker and power

cable connections

NOTE: Never connect cable to the system while it is connected to the battery power. Whenever

the unit is disconnected from the battery, the preset memory will be erased and the unit will go

back to its factory defaults.

When the brown cable for steering wheel control connected to the steering wheel, we can use

the steering wheel to control some unit

Note: To watch video the parking wire should be connected to break signal.

2 cables is connected to a Hands-Free device (not included).

Parking wire

Note: The parking wire is connected with brake signal; for safety, the programs can be seen on

the monitor after braking the car.