VIR-7830B/ VIR-7830BT In-Dash 7” Monitor Touch Screen DVD/CD/MP3/MP4 AM/FM Radio Built-in TV tuner With Bluetooth Owner’s Manual Take the time to read through this owner’s manual. Familiarity with installation and operation procedures will help you obtain the best Performance from your new DVD-receiver.
WARNING! To promote safety, certain functions are disabled unless the parking brake is on. The Unit is designed to detect parked status and must be connected to the power supply side of the parking brake switch. Improper connection or use of his connection may violate applicable law and may result in serious injury or damage. To avoid the risk of damage and injury and the potential violation of applicable laws, this unit is not for use with a video screen that is visible to the driver.
CONTENTS WARNING! ................................................................................................................. 2 OPERATION PRECAUTIONS .................................................................................... 2 Accessories ................................................................................................................ 4 INSTALLATION / UN-INSTALLATION........................................................................ 5 WIRING CONNECTIONS ..................
Accessories Package contains the following accessories for installation and operation of the unit. (1) Washer, Spring Washer, M5 Nut 1 each (2) Mounting Strap 1 (3) Bolt 5*20 1 (4) Screw 4*6 4 (5) Mounting Collar 1 (6) Release Key 2 (7) Screw 5*20 1 (8) Rubber Cushion 1 1x AV-IN Cable Remote Control Warranty card Power Cable RCA Cable User Manual Trim ring Note: Product image may vary from the actual delivery.
INSTALLATION / UN-INSTALLATION Note Before starting installation of the unit, make sure the wiring is connected properly. Use only the parts provided with the unit to ensure proper installation. The use of unauthorized parts may cause malfunction. Install the unit where it does not get in the driver’s way and will not injure the passenger in case there is a sudden stop, like an emergency stop.
WIRING CONNECTIONS NOTE: Never connect cable to the system while it is connected to the battery power. Whenever the unit is disconnected from the battery, the preset memory will be erased and the unit will go back to its factory defaults. Note: To watch video the parking wire should be connected to break signal. 2 cables is connected to a Hands-Free device (not included).
Note: - Only use groundless loudspeakers. - Use only loudspeakers of minimal 40Watt, using fewer watts may result in damaging your loudspeakers at higher volumes. - Use 4~8 Ω (Ohm impedance) loudspeakers only; using higher or lesser impedance may damage the unit. - Do not use 3-cable loudspeakers and do not connect the loudspeakers minus to the car body (GND). The unit is using a BTL circuit and each loudspeaker must be connected with insulated cables according the diagram.
Front panel 1. Release Button Press to detach and release the front panel. When the unit was released, it will switch off automatically after a few second. Detach/Attach the Panel: Press REL button and pull out the left side to detach the panel. To attach it, insert the right side first and then press the left side until hear a click sound. 2. SEL/MUTE Button SEL : Long press it to enter SOUND SETTING menu to adjust the sound settings; EQ => BASS => TREBLE = > BALANCE => FADER => EQ.
4. Button/ Button In RADIO mode, press to start automatic searching, press and hold for two seconds to start manual searching, then press to tune each frequency step downward. In DVD / SD / USB mode, press button to skip to the previous track. Press button and hold for two seconds to activate fast reverse (REW) search in a track. In Bluetooth mode, press to make a call after inputted a phone number or accept an incoming call. 5.
18. SD/MMC CARD slot SD/MMC card slot, for Multimedia playback files only. Insert a SD/MMC CARD into this slot and the unit will automatically start reading and playback the card. * Supported Music File Format: MP3, WMA Files. REMOTE CONTROL 1: 2: 3: 4: 5: 6: 7: 8: 9: MODE POWER BAND/RANDOM/Clear ENTER UP/DOWN/LEFT/RIGHT EJECT STEREO/MONO/* P.
8. P.SCN/ RPT /# In SD CARD/ USB mode, press to repeat REP 1 => REP DIR => REP ALL In DVD mode, press to start repeat REP OFF=>REP Chapter=>REP Title=>REP Off. In Radio mode: PS (Preset Scan): Press to scan all preset stations in the memory of the current band and stay on each memory stations for about 5 seconds. AS (Auto Save): Long press to save the stations with good reception automatically. In BLUETOOTH mode, press it to make a # symbol. 9.
Press it and hold for two seconds in DVD mode to zoom the image in or out in the sequence of ZOOM 2-> ZOOM 3-> ZOOM 4-> ZOOM 1/2-> ZOOM 1/3-> ZOOM 1/4. 23.SEL button Press it to enter the SOUND SETTING menu, and press Cursor UP/DN buttons to choose an item and press cursor left/right buttons to set the item. Press SEL button again to exit the menu. 24. / seek + buttons In DVD mode, Press button to skip to the next track.
REMOVE BATTERY Note: The distance may vary according to the brightness of ambient light. If the remote is not used for an extended period of time, remove the battery to prevent possible damage from battery leakage and corrosion. Do not place any objects between the remote control unit and the sensor on the unit. Do not drop the remote control onto the floor; it will damage it beyond repair.
MAIN MENU The best way to discover the program is to explore each screen in detail, and to find out how to move from one to another. Read this chapter for a guided tour. Unit starts by displaying the Main menu. This is the root of the screen hierarchy, and you can simply access all features by tapping on the touch screen buttons. Tap the icons to enter a desired mode. ◆ RADIO PLAYER To start Radio, tap RADIO button on main menu screen. Mute the sound.
Touch this button to select reception of local station or DX for distance station. ◆ DVD PLAYER To start DVD Player, tap on DVD button from main menu screen. TOUCH SCREEN MENU You will not see any buttons while DVD is played. Buttons will appear when you tap on TFT screen. Tap the screen again to hide the buttons. Insert DVD disc insert VCD disc NOTE DVD Player will automatically start playing when you insert any DVD disc, MEMORY card or USB device. 2.
In VCD mode touch it can choose PBC ON or OFF In DVD mode touch it to enter TITLE MENU (Enable only if the DVD disc with title menu). / Touch it to select previous or next track. / Select the viewing angle of the touch-screen. ◆DISC/USB/SD/MMC interface operation Mute the sound. Decrease the volume. Increase the volume. Stop button. Press it to Stop playback from the current position, press it again to final stop to the very beginning Play/pause button.
◆TV Mode To start TV Mode, tap on TV button from main menu screen. ◆AV-IN Mode To start AV-IN Mode, tap on AV-IN button from main menu screen. Connect the external audio/video signal source to this unit. Select AV-IN mode in the main menu or by pressing repeat Mode button on the front panel. Note: If there is no external video input, the TFT displays “NO SIGNAL”. 1. Press the △ / ▽ icon to adjust TFT angle. 2. Press the icon to be back to main menu.
BEEP LOUDNESS SUBWOOFER Keypad sound setting Set LOUD ON/OFF Set SUBWOOFER ON or OFF DISPLAY CONTROL Tap DISPLAY button to show DISPLAY menu. SCREEN Backlight Screen setting 16:9, 4:3，FULL Backlight setting LOW, MID, HIGH RADIO CONTROL Tap RADIO button to show RADIO menu.. AREA Set AREA:EUROPE-U.S.A-SOUTH AMERICA-RUSSIA STEREO Set STEREO ON or OFF LOCAL Set LOCAL ON or OFF GENERAL CONTROL Tap GENERAL button to show GENERAL 1 menu.
Tap button to show GENERAL 2 menu. CLOCK HOUR CLOCK SETTING AUTO CONNECT Set 24Hour format or 12Hour format Set CLOCK ADJUST time Automatic Bluetooth connection to a previously connected mobile telephone. DVD SET UP MENU Tap the DVD button in main menu to enter the DVD player. Press the SETUP button to enter into the system settings main menu; press the up or down arrow buttons to move to the highlighted menu item and select one of the Setup Pages: [1].
Code 1.NONE 2.G 3.PG 4.PG-13 5.PG-R 6.R 7.NC-17 8. Adult Description Kid safe General Audiences – ALL ages admitted PARENTAL GUIDANCE SUGGESTED-Some material may not be suitable fo r children PARENTS STRONGLY CAUTIONED-Some material may be inappropriate fo r children under 13 Restricted, under 17 requires accompanying parent or adult guardian.
BLUETOOTH SECTION Warning: Driving and having a Telephone conversation at the same time is dangerous, please park your car before having a telephone conversation. The supplier waves any and all liability when this warning is not followed. To enter Bluetooth mode, you can tap Bluetooth icon on Main menu or long press the mute/Bluetooth button on the Remote Control or press mode button on remote or on front panel.
call in its call log . Voice Transfer During a call, you can change a call from Bluetooth mode to phone by tapping Transfer button. To have a call in Bluetooth mode again, tap Transfer button. NOTE: the phonebook only supports Western Characters. Any difference in character will be shown such as “ + , * or # ”. 2. BT PHONE BOOK The unit can downloading the data from phone automatically when the pairing between a phone and the unit be completed.
TV SECTION (For VIR-7830BT only) Connect a TV antenna to the TV antenna jack of the unit. Select TV mode, and then touch the center of the display; following interface will be display. In TV mode, press the Play/Pause buttons on front panel or remote once to enter TV menu setting; or press TV MENU icon on the main menu to enter TV menu. 1. Press the / on remote or tap the screen to select one of the setup pages: Auto program => Manual program. 2. To enter the selected page press ENTER button on the RC.
Manual program (manual seek mode) Storage Select this menu item is to set the storage number. System Select this menu item is to set TV system: SECAM => NTSC =>PAL, press NTER button on the remote touch corresponding option on the touch screen to select. Audio Select this menu item is to set the TV sound system: 1) When system settings PAL, press ENTER on remote or tap the screen button to select TV sound system: D/K=>M/N=> B/G=> I. 2) When system setting SECAM, TV sound system B/G=>I=>D/K.
NOTES ON DISC Only use groundless loudspeakers. Use only loudspeakers of minimal 40Watt, using fewer watts may result in damaging your loud speakers at higher volumes. Use 4~8 Ω (Ohm impedance) loudspeakers only; using higher or lesser impedance may damage the unit. Do not use 3-cable loudspeakers and do not connect the loudspeakers minus to the car body. (GND). using a BTL circuit and each loudspeaker must be connected with insulated cables according the diagram.
TROUBLESHOOTING Symptom LCD CD General Power does not turn on. (No sound is produced.) No sound output when operating the unit with amplifiers or power antenna attached. Cause Remedy Fuse is blown In correct wiring Power antennal lead is shorted to ground excessive current is required or remote on the amplifiers or power antenna. Nothing happens The microprocessor when buttons are has malfunctioned pressed. due to noise, etc.
TROUBLESHOOTING SYMPTOM NO POWER DISC CANNOT BE LOADED. CAUSE THE CAR IGNITION IS NOT ON. THE FUSE IS BLOWN. REPLACE THE FUSE. PRESENCE OF DISC INSIDE THE PLAYER REMOVE THE DISC IN THE PLAYER THEN PUT A NEW UPWARD. INSERT THE COMPACT DISC WITH THE LABEL FACING UPWARD. CLEAN THE DISC OR TRY TO PLAY A NEW ONE. INSERTING THE DISC IN UPSIDE DOWN. DISC CANNOT BE READ. SOLUTION IF THE POWER SUPPLY IS PROPERLY CONNECTED TO THE CAR ACCESSORY SWITCH THE IGNITION KEY TO “ACC”.
TECHNICAL SPECIFICATIONS General Power supply: Current consumption: Maximum power output: Compatible formats: Dimensions (W x D x H) / weight: Working temperature range: ESP function: 11~16V DC max. 10 A 52W x 4 channels (max) DVD/SVCD/VCD/HDCD/MP3/MP4/VIDEO/CDDA/Picture CDCD-R/-RW/DVD±R/±RW playback 165*178*50 mm/2 kg -10℃ - +60℃ 10 sec. for Audio CD, 120 sec.
