Owner's Manual

CM31-EZ
Sheetrock Installation Instructions For:
1.435.647.9555 I 800.647.TUBE I www . soundtube.com
CM31-EZ speaker
1. Unpack speaker. Leave
paint mask in place until
after speaker
is installed or
painting is complete.
5. If required, attach seismic
restraint system
to hole in
clamping arm, then
to
reinforced structure (safety
cable
not included).
-2 .
9. Attach grille safety clip by
placing the large end of the
clip over snap-fit post (1 ), then
sliding clip until small end
snaps
into place around post
(2).
2. Use included tile bridge to
mark cutout on sheetrock.
Tile bridge ships in separate
box.
6. Insert speaker into
mounting hole with paint
mask
in place. Tighten both
bolts on the baffle face to
actuate the mounting wings.
Firmly secure
both bolts, DO
NOT OVERTIGHTEN.
1
1
10. Align tabs on snap-fit grille
with slots in baffle, gently
press grille into place.
3. Use RotoZip or other tool
to cut hole. Hole diameter:
5.6 in. (142 mm).
7. Remove paint mask
unless painting
is required.
In
that case, follow steps
8-11 when painting is
complete.
0
11. Done!
4. Feed speaker wires
through conduit clamp and
connect
with wire nuts. Push
wire nuts into backcan and
affix
conduit clamp.
8.
Adjust tap switch to
proper setting . Switch is
preset to the highest
setting in the 70.7- volt
mode .