Owner's Manual

Install Instructions For:
RSi Series
RS4-EZ, RS400i, RS500i, HP590i, RS600i, HP690i, RS800i, HP890i, RSlOOli-11, HP129i & HP1290i speakers
1. Unpack speaker and
SpeedCiamp '"' mounting
hardware.
2. Select the tap position by 3. Slip terminal weather
removing the rubber plug
on boot over signal wire. For
gri lie to access rotary switch.
en vi ron menta I applications,
Switch is preset to maximum
put RTV silicone around
tap setting in
70.7Vmode. nipple and base when
Select desired setting and installation is complete.
reinsert rubber plug.
Note: The
grille-mounted
tap switch
cover is keyed; be sure
flat
edge of plug lines up with flat
edge of hole in grille.
5. Thread hanging or safety 6. Attach the hanging cable
cable through SpeedCiamp
TM by securing it and safety
7. Thread cable end(s)
through SpeedCiamp '
"'
mechanisms as shown. mechanisms as shown. cable to structure as shown.
9. Attach hanging cable to
the center hole in the
speaker hanging bracket.
10. Attach the safety cable to
one of the secondary holes
in
the hanging bracket.
11. Insert 4-pin Euroblock
plug into Euroblock jack on
rear
of speaker. Connectors
are keyed for polarity.
4. Connect signal wire to
4-pin Euroblock plug. Tighten
unused terminal screws.
Use
inside positive and negative
inputs for either voice coil or
distributed systems.
For daisy
chaining,
use outside positive
and negative terminals.
8. Adjust speaker hanging
height
with SpeedCiamp '"'
mechanism. Pull to tighten &
insert release
key (small hex
wrench) into SpeedCiamp '"'
as shown to loosen or adjust.
12. Use zip or twist-lock ties
to secure safety cable
& signal
wire
to main hanging cables.
Cable cover available for
asthetic applications
(SL T -10).
SoundTube also provides optional surface mount brackets for both the RS and HP lines of products.
Installation instructions for these accessories are included with specific accessory packaging.