Owner's Manual

1.435 .647. 9555I800 .647.TUBE I www . soundtube.com
RS-EZ series I
Install Instructions For:
RS42-EZ-WH, RS42-EZ-BK, RS62-EZ-WH & RS62-EZ-BK
1 . Unpack speaker and
SpeedCiamp
TM mounting
hardware.
2. Thread hanging or safety
3. Attach the hanging cable 4. Thread cable end(s)
cable through SpeedCiamp
TM by securing it and safety through SpeedCiamp TM
mechanisms as shown. cable to structure as mechanisms as shown.
5. Adjust speaker hanging 6. Slide cover plate over
height with SpeedCiamp
rM hanging and safety cables
mechanism.
Pull to tighten & and run signal wire through
press button on SpeedCiamp center hole.
as shown to loosen or adjust.
8. Extra slot and 2 holes
provided for additional
safety cables where
needed.
12. Tighten
all four (4) screws
to lock cover plate
in place.
9. Connect signal wires to
(+)and(-) inputs. Use extra
(+)and(-) for daisy
chaining.
13. Install rubber weather
plug by sliding slit over the
wire, then pressing snuggly
into hole
in cover plate.
7a. Attach hanging cable
by
(1) inserting into side of
mounting bracket and
(2)
rotating to align with center
slot
in hanging bracket.
1
0. Select desired tap
position. Switch
is preset to
maximum
70. 7V (1 OOV)
mode.
14. Done.
7b. Once aligned with central
slot, pull cable up into slot
to
secure. Repeat steps 7a and
7b with secondary safety ca-
ble into one of the side slots.
11 . Place cover plate onto
top of speaker and rotate
clockwise until alignment
indicators meet.