User Manual For Ulite 2000
THANK YOU FOR YOUR PURCHASE
Contents Introduction .................................................................................................... 1 Components ................................................................................................... 2 Preparation ..................................................................................................... 3 Low Battery Warning ................................................................................... 4 Replacing the Battery ..............................
Introduction Congratulations! Welcome to a new life created by Ulite 2000. Please read this manual carefully before use. Ulite 2000 is Bluetooth compatible product which can be connected to the SOUNDWEAR® App for optimized settings. Intended use PSAPs (Personal Sound Amplifier Product) help to reduce situational listening stress in many communication environments. Hearing better means a better life in significant measure.
Components Sound Tube Microphone Battery Door Amplifier/Receiver Dome 2
Preparation What’s In the Box? 1 x Ulite 2000 1 x User Manual 1 x Cleaning wire & brush Battery Care The Ulite 2000 uses a 312A zinc air battery as its power source. The performance of the hearing instrument greatly depends on the quality of the battery used. It is important to use high-quality batteries. With reliable highquality batteries, you can avoid periodic hearing instrument failures. It is also important that the batteries are well packed before use.
NOTE: Batteries are dangerous if swallowed! Keep batteries away from children and pets. In case a battery has been swallowed, seek immediate medical attention. Low Battery Warning When you hear one short beep, it means that the battery is running out. Intermittent warning exists until you replace the battery. The sound quality may be influenced after the first warning, this is normal and can be remedied by inserting a fresh battery in the hearing instrument.
Operating Turn on your hearing instrument by closing the battery door completely. Turn off your hearing instrument by opening the battery door slightly. Attaching Hearing Amplifier Parts 1. Gently push the dome over the grooves of the end of the sound tube. 2. Once the dome and tube are properly aligned at the tip, make sure the hole in the dome tip is aligned with the sound hole at the tip of the earpiece.
How to Wear Your Hearing Instrument 1. Hold the tubing with your thumb and index finger close to the earpiece and gently insert it into the ear. 2. Place the part of the hearing device that contains the battery, over the top of the ear. 3. Gently insert the earpiece further in the ear canal until it feels snug and comfortable. You may hear the instrument ‘squeal’ or “whistle” while inserting. That is a natural indication that the battery is good and device working.
Memory Switch Your hearing amplifier is programmed with 4 different listening programs. When the hearing instrument is turned on, it will automatically be in program 1. The additional settings which are pre-programmed for your specific needs are accessed by the SOUNDWEAR® App. The sequence is 1, 2, 3, and 4. The Ulite 2000 is equipped with the adaptive directional (dual) microphones function. Adaptive directional microphones can provide improved speech recognition in noise.
Maintenance Cleaning Do not use water or other fluids to clean the hearing instruments. There should always be care in handling the hearing instrument to prevent them from falling onto any hard surfaces, such as counter top, table or floor. Do not leave your hearing instrument in the direct sun or in areas where the temperature can rise over 60°C / 140°F for extended periods of time. Avoid cleaning with any harsh chemicals or strong cleaners. Keep the hearing instrument clean and dry.
Troubleshooting 1. What if the it is not loud enough? Try to adjust your volume in the app to get better hearing results. Then, clean the tube and dome to ensure the passageway is clear. If it is still not loud enough, you may want to contact your physician and get a hearing exam done. 2. What if my device isn't turning on? Be sure that the battery is inserted properly and the battery door is completely closed. 3. There is no sound? First, check if the battery is low or dead.
Bring Your Hearing Back to Life