User Manual

SA260 Nemesis Delay User’s Guide 7
MIDI Input
This is a standard 5-pin DIN connector that accepts MIDI control messages from external devices,
including program changes, continuous controllers (CCs), and MIDI clock. See the “Nemesis MIDI
Implementation” document for details.
Output Side Connections
Output 1
This is the primary audio output. Connect it to your amplifier, recording interface, or the next device
in your effects signal chain using a mono (TS) ¼” cable.
Output 2
OUTPUT 2 can act either as an audio output, external loop output, or as the daisy-chain data
connection for the Neuro App.
Output 2 as an Audio Output
The tip contact on OUTPUT 2 acts as the secondary audio output. It carries an audio signal when the
Nemesis is configured with a signal routing that uses stereo outputs. Connect it to your amplifier,
recording interface, or the next device in your effects signal chain using a mono (TS) ¼” cable.
Output 2 as an External Loop Send
If the Nemesis is configured in a routing mode that includes an external loop, OUTPUT 2 is the loop
send and INPUT 2 is the loop return. Connect OUTPUT 2 to the input of the external effects loop using a
mono (TS) ¼” cable.
Output 2 as a Neuro App Data Daisy-Chain Output
The ring contact on OUTPUT 2 acts as a data connection for the Neuro App, passing data from the
Nemesis to the next Source Audio effect in your signal chain. You can daisy-chain the Neuro App data
regardless of whether OUTPUT 2 is configured to output audio or not. Connect OUTPUT 2 to the next
device’s Neuro App Data input (usually INPUT 2) using a stereo (TRS) ¼” cable. The audio signal (if