User Manual
Table Of Contents
- Welcome
- Overview
- Quick Start
- Connections
- Basic Tremolo Operation
- Effect Types
- Controls
- Preset Storage and Recall
- Universal Bypass TM
- Stereo Routing
- Parametric EQ
- External Control
- Neuro App
- Specifications
- Troubleshooting
- Frequently Asked Questions
- How do I change the routing mode for my pedal without changing anything about the sounds?
- What kind of instruments can I connect to the Vertigo’s inputs?
- Can I power the Vertigo directly over USB, without using the 9 Volt supply?
- When connecting the Vertigo to a recording interface or mixer, should I used a Lo-Z (microphone) or Hi-Z (line / instrument) input?
- Why doesn’t the Vertigo respond to MIDI messages being sent to it?
- How do I enable extended effect types via MIDI?
- Can I use the Vertigo in my amp’s effects loop?
- Rubber Feet
- Waste Disposal Notes
- Warranty
- Version History
SA243 Vertigo Tremolo User’s Guide 34
App. Channel numbers in MIDI use zero-based counting, so MIDI channel 1 is described as 0 in
hexadecimal, MIDI channel 2 is described as 1 in hexadecimal, and so on, concluding with MIDI
channel 16, which is described as F in hexadecimal. A continuous controller message starts with a
hexadecimal B and is followed by the channel number (0 through F). So, the command byte from
your MIDI controller should be formatted as shown in the following table:
MIDI Channel
(Decimal)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
CC Command Byte
(Hex)
B0
B1
B2
B3
B4
B5
B6
B7
B8
B9
BA
BB
BC
BD
BE
BF
Each continuous controller command byte is followed by two bytes, the CC number and the value. So,
each CC message consists of a total of three bytes. If the Vertigo is not responding to MIDI, make
sure that your MIDI controller is properly configured and sending messages in the format described
above.