Owner's manual

External Control | 17
Press the NOISE GATE button again while holding the TONE SHAPE
button to resume normal Noise Gate adjustments
CONTROL ASSIGN
Both the expression pedal and hot hand inputs are by default mapped to
control the morph parameter. This effectively allows the control of any
parameter since the morph is between two distinct preset effect settings.
Alternatively, it might be desirable to assign control of an individual knob
parameter to the Hot Hand or Expression input instead of the default
Morph parameter. To assign control to a knob:
1. Ensure that you are in external control edit mode (NOISE GATE LEDs
are red)
2. Select the desired external control option: EXP for expression pedal,
HH for Hot Hand.
3. Press and hold the NOISE GATE button until the red LED begins to
blink slowly.
4. Set the low position of the desired knob, for example DRIVE, to the
lowest setting you would like to use.
5. Press the NOISE GATE button again and the LED will now blink rapidly.
6. Set the desired high position you would like to use.
7. Press the NOISE GATE button to complete the assignment. The LED
will blink 3 times to indicate the process is complete.
The same process can be used for either EXP or HH modes. To return to
the default Morph control, set the external control to OFF. Press and hold
the NOISE GATE button again until all three LEDs blink rapidly.
Note: Different control assignments can be used for each preset. Don’t
forget to save your settings!
- Continued