Manual

20 | Use with Hot Hand

USE WITH HOT HAND

All Soundblox pedals are compatible with our Hot Hand accessories.

Hot Hand units consist of a ring-mounted accelerometer that translates

motion into a control signal that can be applied to effect parameters. On

the OFD, connect Hot Hand to the Multi-Function input. Select the HH

mode as the external control option. This will take the input signals from

Hot Hand and use them to control either the Morphing function or the

assigned knob parameter (See Control Assign Section).

The Soundblox 2 OFD microModeler can also be calibrated to change the

midpoint of the Hot Hand control range — for instructions, follow the cali-

bration procedure below. Note that Calibration is only used for Hot Hand

mode and calibration is NOT required before use.

To perform a calibration:

1. Select a preset by pressing a footswitch.

2. Enable Hot Hand control by selecting HH mode from the external

controls (See External Control section).

3. Press and hold the NOISE GATE button until the HH red LED begins to

blink slowly (this is the same as the control assign procedure).

4. Put the Hot Hand sensor into the desired calibration position.

5. Press the footswitch for the currently selected preset.

6. The HH LED will blink when the calibration is complete.

If you have trouble with calibration and need to get back to the default

setting, place the sensor on a ﬂat, level surface with the blue LED facing

down and run the calibration procedure again.