User Manual

Controls: Knobs | 11

• MIX (Red LED): The MIX knob controls the ratio between the wet

and dry signals. This knob is split into two regions: normal and

inverted wet signals. The 12 o’clock position produces a 100%

dry signal—as the knob is turned clockwise from 12 o’clock the

wet signal gradually increases as the dry signal decreases until

reaching a 100% wet mix at its right-most position. The process

is repeated with an inverted wet signal in the counter-clockwise

direction. The inverted wet signal interchanges the positions of

the peaks and valleys in the frequency response and tends to

reduce bottom end. The marks at approximately 10 and 2 o’clock

around the MIX knob indicate the point of a 50/50 wet/dry mix.

Set the MIX knob to a 50/50 ratio for the most prominent phase

or ﬂange effects.

Factory Defaults: Given the number of different functions available on

the OPTION KNOB, it can be useful to “zero” all of the controls to a

default value. We pre-loaded the Orbital Modulator with unique default

settings that are a good starting point for each effect type (note: the

CLASSIC effect type defaults to a ﬂanger setting). You can recall these

values at any time by pressing and holding the OPTION SELECT button

until its three LEDs blink two times.

Note: To learn the knob positions of the default settings, go to the

SB2 Orbital Modulator product page on our website and download the

PDF titled, SB2 Orbital Modulator Preset Suggestions.

- Continued