User manual

Source Technologies, LLC ST9630 Secure MICR Printer User’s Guide

This command identifies the data to be printed in the first column of the report. It is a

maximum of 14 characters in length. If less than 14 characters are sent, the printer fills

the field with spaces when the audit report is printed. This field is only recorded in the

audit report; it is not printed on the check.

Audit Report Field Two-MICR Line &%SMDd..d$ or &%SM7d..d$

&%SMD or &%SM7 Lead in sequence

d..d Data to be printed

$ Command terminator

This command identifies the data to be printed in the second column of the report. It is a

maximum of 40 characters in length.

Audit Report Field Three &%SQ3d..d$

&%SQ3 Lead in sequence

d..d Data to be printed

$ Command terminator

This command identifies the data to be printed in the third column of the report. It is a

maximum of 40 characters.

Audit Report Field Four &%SQ4d..d~

&%SQ4 Lead in sequence

d..d Data to be printed

~ Command terminator

This command identifies the data to be printed in the fourth column of the report. It is a

maximum of 16 characters in length. Since a total of this field can be provided at the end

of the Audit Trail Report it is typically used for the convenience amount field.

Note: This is the only command where the $ is not a command terminator. The

tilde ~ (hex 7E) acts as the command terminator.

Audit Report Field Five &%SQ5d..d$

&%SQ5 Lead in sequence

d..d Data to be printed

$ Command terminator

This command identifies the data to be printed in the fifth column of the report. This field

is a maximum of eight characters.

Audit Report Field Six &%SQ6d..d$

&%SQ6 Lead in string

Audit Trail Reports | 8