Printer User Manual

Source Technologies, LLC ST9650 Secure MICR Printer User’s Guide

Print MICR CMC7 Font &%SM7ddd...ddd$

&%SM7 Lead in sequence

ddd...ddd Data to be printed in CMC7 font

$ Command terminator

Prints the specified data in the CMC7 MICR font which is used in Europe and South

America. The font and its correct spacing begin at the current cursor position modified by

the MICRpoint adjustment setting at the start of the command. After the terminator is

sent, the printer will return to its default font, and the MICR count will be decremented by

one. Upon receiving this command the printer will check to ensure a MICR toner

cartridge is installed and set the copies parameter to 1. See Appendix B for CMC7

character mapping.

Print Secure Numeric Font &%SMFddd..ddd~

&%SMF Lead in sequence

ddd...ddd Data to be printed in this font

~ Command terminator

The dollar sign ($) is not a command terminator for this command. For both security

fonts the tilde ~ (hex 7E) is the command terminator since the dollar sign is a valid

character.

Print ICR Secure Numeric Font &%SMIxxxxxx~

&%SMI Lead in sequence

xxxxxxxx Data variables to be printed in this font

~ Command terminator

Print MicroPrint Line &%SMMxxxxxxxxx!$

&%SMM Lead in sequence

xxxxxx Data to be printed in this font

! MP designator (optional)

$ Command terminator

If the exclamation point (!) is used, the “MP” designate will print just above and to the

right of the last character. This is optional and is typically used to notify the check

recipient of the presence of MicroPrinting. Only 0-9, A-Z (upper and lower case) print.

Special characters and spaces will disappear.

MICR Features | 6