Owner manual

Source Technologies, LLC ST9620 Secure MICR Printer User’s Guide

The commands in Figure 7.1 in order of appearance:

&%STFPASSWORD$ Password Command.

&%SMCP0001$ MICR Definition Command with the count set to one.

&%STP10001$ Unlock Flash Resource number 10001.

&%STP20000$ Unlock Flash Resource number 20000.

&%1B26...3358$ PCL sequence in hex which sets the page format and

enables macro number 10001.

&%1B$(s1p16v0s3b4148T PCL sequence which changes the font to Univers 16

point. After the check serial number prints (1000), the

printer is returned to its default font with the following

command.

&%1B$(3@ PCL command to return to default font.

&%SMF$2014.44~ Print Secure font command.

Note: The tilde ~ is the command terminator.

&%1B$(s0p12h1s0b4099T PCL command to change the font to Courier 12 pitch

Italic. Print PCL Fonts from the Front Panel menu for a

list of fonts with their call commands.

&%1B$(3@ PCL command to return to the default font.

&%1B$(20000X! PCL command to print font number 20000. In this

example font 20000 is a signature previously loaded into

flash memory. Here we call it and print it with an

exclamation point (!).

&%1B$(3@ PCL command to return to the default font.

&%1B$&f0S PCL command to Push (store) the current cursor

position.

&%1B$*p296x3184Y PCL command to move the cursor to 296X , 3184Y. At

300 units of measure, this is .97 inches across and 10.61

inches down. We are precisely positioning the MICR

line.

&%SMD....$ Print E-13B MICR Command. This prints the MICR line.

Note: Refer the MICR font character mapping in

Appendix A.

&%1B$&f1S PCL command to Pop (return) the cursor to the pushed

position.

IBM Host Programming Features and Examples | 7