Datasheet

20
CLIPPER
Jacketed Cable Stripping Length
Make a 90° cut at the cable end.
carefully make an incision in order to remove the cable
protection on a length LD as described.
Caution : This operation should be realized without
deterioration of wires insulation.
Then, follow the normal stripping instructions :
- single wire with machined crimping contacts,
- single wire with stamped and formed crimping
contacts
Shell size 1 2 3 4
layouts Indifferent 26 40
LD mm 60 65 65 80 100
(inch) (2.36") (2.56") (2.56") (3.15") (3.94")
Wiring Instruction
Stripping Instructions
Use the upmost care with stripping operation :
• Use stripping pliers appropriate for the cable gauge and which are in perfect condition.
• In order to obtain a correct crimping and to maintain all of the connector sealing characteristics, the wires must
have the dimensions described below.
Wire Stripping Length
• With machined crimping contacts • With stamped and formed crimping contacts
Contact
size l = Wire stripping length
#16 6 mm (.236")
#20
Ø over insulation ≤ 2 mm " l = 5 (≤ .08" " l = .20")
Ø over insulation > 2 mm " l = 7 (> .08" " l = .27")
Contact
diameter l = Wire stripping length
#16 4 mm (.157")
#20 4 mm (.157")
l