Datasheet

Clipper Industrial Plastic Connectors

Panel mounting

There are two types of mounting possible: through the front or through

the back of the panel.

Panel cut-out

• For a sealed mounting, the seal gasket shall be used, making sure the

surface is in good condition.

• Observe the drilling hole diameters indicated below.

• Use the recommended screws :

M3 (all shells)

or # 4.40 (shells 1 and 2)

# 6.32 (shells 3 and 4)

• Respect the coupling torques indicated M3

(all shells) : 0.70 N.m Max

Rear Mounting

.157" max

(4 mm max)

Front Mounting

.157" max

(4 mm max)

Panel mounting / Panel cut-out

1234

H .85 .98 1.22 1.61

I .84 .97 1.13 1.44

J .13 .13 .15 .15

Dim.

(inches)

Shell

sizes