Datasheet

16
Pin protection shroud for panel mount receptacle
Part number
Nbr. of contact
position
A B
Black UL94 V2
SMS2CSB1 2 19.8
18.8
SMS3CSB1 3
23.4
SMS4CSB1 4
28.4
SMS6CSB1 6
23.4
23.9
SMS9CSB1 9
29.0
SMS12CSB1 12
34.0
SMS15CSB1 15
39.1
SMS18CSB1 18
44.2
SMS24CSB1 24
28.4
SMS36CSB1 36
54.1 34.0
A 23.5
B
When pins are inserted into the panel mount
receptacle half (SMS...R1) of the Quick Mating
connector, an optional pin protection shroud
can be installed.
The shroud is mounted at the same time as
the receptacle by holding the shroud against
the mating side of the panel with both cut-
outs lined up. The receptacle is then inserted
in place, trapping the shroud between the
receptacle and panel. The use of the pin
protection shroud reduces the allowable
thickness of the panel from 2.3 to 1.6 mm max.
Strain relief hoods
Part number
Nbr. of contact
position
Black UL94 V2
SMS2H1 2
SMS3H1 3
SMS4H1 4
SMS6H1 6
SMS9H1 9
SMS12H1 12
SMS15H1 15
SMS18H1 18
SMS24H1 24
SMS36H1 36
Separate strain relief hoods are available for all standard plugs SMS...P1.
The hoods consist of identical halves that snap into position on the plug
and are secured in place with the cable tie drawn tightly around the cable
entry collar.
The cable tie is not included (TF4D – TF5D).
Two, three and four position hoods are single piece units.
For SMS2H1, SMS3H1, SMS4H1
& SMS6H1
2 pieces are needed for a
complete hool for SMS9H1
to SMS36H1
Discrimination pins
For discrimination pins on both standard Quick Mating and Quick Mating Pin Headers cable and board mount:
See page 27.
Accessories for standard Quick Mating connectors
SMS Series
|
Quick Mating
Note: all dimensions are in mm