Datasheet

151
• Strip wires and crimp contacts (see pages 140 & 141)
• Insert rst contact into the grommet (rst contact in cavity A,
no tool is required). Then insert the contact in the connector
cavity A (insert manually or use tool RTM2 0 5)
• Insert the other contacts
• Tighten the nut to rear of either UTO7 or UTO6 (recommended
torque values to be applied according to the table below).
Nut
UTO6 or UTO7 with GN Backshell Assembly
UTO7
UTO6
Shell size layout Nut tightening torque (Nm) Ø Wire
10 4 1
From
1.7 mm
to
3.0 mm
12 8 1.5
14 7 1.5
14 12 1.5
Grommet +
compression ring
UTO Series
|
Technical Information
Technical Information