Datasheet

152
• Strip wires and crimp contacts (see pages 140 & 141)
• Insert rst contact into the grommet (rst contact in cavity A,
no tool is required). Then insert the contact in the connector
cavity A (insert manually or use tool RTM2 0 5)
• Insert the other contacts
• Tighten adapter with plug, choose right seal (waste the other
seal)
• Tighten the nut to rear of either UTO7 or UTO6 (recommended
torque values to be applied according to the table below).
Nut
Cable range
UTO6 or UTO7 with GJC Backshell Assembly
Adapter + mounted gasket
UTO7
Grommet +
compression ring
UTO6
Cable ranges
Reducing Standard
Assembly Instructions (Continued)
Shell
size
Layout
Recommended jacket
strip length (mm)
Adapter tightening
torque (Nm)
Nut tightening
torque (Nm)
Ø Cable range
Standard seal
(mm)
Ø Cable range
Reducing seal
(mm)
Ø Wire
Male Female
10 4 21 29 1.5 1 2.5/8.0 1.5/5.0
From
1.7 mm
to
3.0 mm
12 8 25 33 2 2.5 5.0/12.0 3.0/9.0
14 7 29 36 3 2.5 7.0/14.0 5.0/12.0
14 12 29 36 3 2.5 7.0/14.0 5.0/12.0
UTO Series
|
Technical Information