Brochure

159
© 2011 – SOURIAU
Shell size
Nut tightening
torque (Nm)
Ø Wire
10 1
from
1.7 mm to
3.0 mm
12 1.5
14 1.5
Nut
Grommet
+ Compression ring
Optional
coding ring
• Slide accessories on the cable (make sure to keep compression ring on the grommet)
• Strip wires and crimp contacts
• Insert fi rst contact into the grommet (fi rst contact in cavity A, use male contact to
pierce the grommet, no tool is required), then insert the contact in the connector
cavity A (insert manually or use tool RTM2 0 5)
• Place the grommet and compression ring on the insulator
• Insert the other contacts
• Tighten nut (recommended torque: see note)
Shell size
Jam nut
torque
(Nm)
Tool
tightening
Ø Wire
Standard
version
Discrete
wire
sealing
8 1.5 19.05
3.2 mm
max.
from
1.7 mm
to
3.0 mm
10 3 22.25
12 427.15
14 5 30.19
18 5 36.5
• Strip wires, crimp or solder contacts
• Insert contacts into connector cavities (insert
manually or use tool RTM2 0 5 crimp contacts only)
• Seat o-ring, place receptacle in the panel cut-out
• Tighten jam nut
O-ring
O-ring
Jam nut
Jam nut
Panel thickness:
3.2mm max
Panel thickness:
3.2mm max
Optional
coding ring
Optional
coding ring
Crimp version
Solder version
Finally
UTS Series
Technical information
UTS 7 assembly (mounting suggestion)
UTS 6 GN / UTS 7 GN assembly
Technical information