Datasheet

181
UTS Series
|
Technical Information
UTS7 Assembly (Mounting Suggestion)
UTS6 or UTS7 with GN Backshell Assembly
Nut
Grommet
+ Compression ring
Optional
coding ring
Shell size
Jam nut
torque
(Nm) maxi
Exterior
jam nut
dim. (mm)
Ø Wire
Standard
version
Discrete
wire
sealing
8 1.5 19.0
3.2 mm
max.
from
1.7 mm
to
3.0 mm
10 3 22.2
12 4 27.0
14 5 30.1
18 5 36.5
Shell size
Jam nut torque
(Nm) maxi
Threading
P mini
(mm)
8 2.5 M12 x 1.5 7.7
10 3.75 M16 x 1.5
12 3.75 M20 x 1.5 10.4
14 4.18 1/2" 8.3
18 4.76 3/4" 11.6
• Strip wires and crimp contacts (see pages 176 & 177)
• Insert contacts into connector cavities (insert manually or use tool
RTM2
0 5 crimp contacts )
• Seat o-ring, place receptacle in the panel cut-out
• Tighten jam nut
O-ring
Jam nut
Receptacle
Panelthickness:
3.2mm max
Panel
thickness
P
Optional
coding ring
Crimp or solder version
Threaded version
• Strip wires and crimp contacts (see pages 176 & 177)
• Insert rst contact into the grommet (rst contact in cavity A,
no tool is required). Then insert the contact in the connector
cavity A (insert manually or use tool RTM2 0 5)
• Insert the other contacts
• Tighten the nut to rear of either UTS6 or UTS7 (recommended
torque values to be applied according to the table below).
Shell size layout
Nut tightening
torque (Nm)
Ø Wire
10 4 1
From
1.7 mm
to
3.0 mm
12 8 1.5
14 7 1.5
14 12 1.5
UTS7
UTS6
Threaded receptacle
Technical Information