Datasheet

178
UTS Series
|
Technical Information
Handle & Interchangeable Heads
User Guide
8) To control crimp quality, slighty pull cable with two ngers
to control retention.
3) Close the two pins simultaneously to maintain the head.
7) To crimp contact assembly-cable, tighten sharply the clip
to the end of the mechanism (maxi 175N).
2) Choose the adapter head (sold separately), keep vertical and
slide it into the handle until the mechanical end.
6) Position the contact in the bottom of the tool by checking
its orientation.
1) Fully close then release the tool, keep it open.
Open the 2 pins.
5) Place conductors, with no deteriorations, in the bucket contact.
All strands to be located in the crimp bucket.
4) Strip the cable properly check the recommended size
in the catalog on page 176.
GOOD WRONG WRONG