Datasheet

183
UTS Series
|
Technical Information
•
UTS6JC Screw Termination Assembly
Shell
size
Recommended jacket
strip length (mm)
Adapter
tightening torque
(Nm)
Nut
tightening torque
(Nm)
Ø Cable range
Standard seal
Ø Cable range
Reducing seal
Ø Wire
Male Female
12 22.8 max 15.1 max 2 2.5 5.0/12.0 3.0/9.0
From 1.7 mm
to 3.0 mm
14 26.7 max 18.9 max 3 2.5 7.0/14.0 5.0/12.0
• Mate the plug with a corresponding receptacle equiped with
its contacts
• Choose and place right seal depending on cable diameter
(see table below)
Receptacle
Plug
Nut
Note: all dimensions are in mm
• Strip the wires (strip length 5.8 mm)
5.8mm
1
• Place the conductors in the contact barrel.
Make sure all conductor strands are inside the barrel
• Tight the contact screws, advised torque 20 Ncm
Torque:20Ncm
Head dimension 04 x 2mm
4
• Slide accessories on the cable
• Strip external jacket (see table below).
2
• Check the mechanical cable retention, by gently pull the cable
with 2 ngers
• Tighten adaptater with the plug (recommended torque: see table)
5
3
• Tighten backshell nut with adapter
(recommended torque: see table below)
(cables should not turn into the backshell during this operation).
6
Technical Information