Instruction Manual


Chapter4. Radio wireless data transmission and control radio station introduction
The wireless connection of radio and RTK.
The Bluetooth of the handbook is connected to the host to set the base station plug-in
mode and starts successfully. The handbook disconnects the Bluetooth connection to the
radio wifi and enters the radio page 10.1.1.1 for related operation settings. (account and
password are admin)
The steps of Web page seting
1.1 Open Web Page > Radio Settings > Radio Parameters > Data Source (Set to
Bluetooth) > OK.
1.2 Data Transmission > Serial Port Settings > BLUETOOTH > Baud Rate
(corresponding to RTB Host Serial Port Baud Rate) > Parity > Data Flow > Enable
(Select) > OK. (Note: LEMO is the setting when using the data cable)
Serial port settings generally do not need special settings, keep the default (as shown
below)

1.3 Network Settings > Bluetooth Settings > Advanced Settings > Main Mode (Select
Main Mode) > Search Bluetooth > Please select (Select Base Station RTK Host
Bluetooth) > OK. (Please restart the radio after switching the Bluetooth working mode.
If the restart is not restarted, the setting will not be successful.)
