Freezer Base (Remote Condenser) Spec Sheet

1100 Old Honeycutt Road, Fuquay-Varina, NC 27526
[phone] www.southbendnc.com
Models:
www.yatesgd.com www.yatesgraphicdesign.com
72" (1829) 84" (2134)
64" (1627)
96" (2438)
48" (1219)
108" (2743)
25"
(635)*
Each 18" drawer
holds one pan
18" (457)*
Each 26" drawer holds
two pans front-to-back
26" (661)*
Each 31" drawer holds
two pans side-by-side
31" (787)*
TOP VIEW Showing Extended Drawers
36" (914)
RIGHT SIDE -32" REAR VIEW -32"
26"
(660)
36" (915)*
6" (152)
Condensate
Drain Tube
Power
Cord
RIGHT SIDE
26"
(660)
32.5" (826)*
6" (152)
1" (25)
1" (25)
32" (813)
FRONT VIEW -32"
Power cord and condensate drain tube
located behind left sidepanel.
Tubing Cover for 60” and larger units.
INTENDED FOR COMMERCIAL USE ONLY.
NOT FOR HOUSEHOLD USE.
MISCELLANEOUS
UTILITY INFORMATION
- If casters are used with ex hose, a restraining
device should be used to eliminate undue strain on
the ex hose.
- Minimum clearance on rear is 2” (51 mm)
- Modular range top sections can be mounted
directly on top using an insulated base adapter.
- Can be part of sectional battery, provided that
the adjoining base sections are insulated, or do not
produce heat.
- Avoid locating where the temperature will drop
below 55°F or rise above 90°F
- Check local codes for fire and sanitary
regulations.
NOTICE:
Southbend has a policy of continuous product
research and improvement. We reserve the
right to change specications and product design
without notice. Such revisions do not entitle the
buyer to corresponding changes, improvements,
additions or replacements for previously purchased
equipment.
All models have a six foot power cord with a grounded plug to receive 50Hz or 60Hz
single-phase AC. Condensate drain is a 1/2” inside diameter vinyl tube. Condenser unit
is NOT included.
Form PRF Rev 6 (August/2014)
OPTIONS AND ACCESSORIES
The drawer-front width, drawer-extension distance, and overall depth may vary (the maximum values are specied and shown)
 Cable restraint kit (to restrict movement when on casters)
 Casters -front two casters lock
 Open-frame base with casters
Model Width
# of
Drawers
# of
Pans
Cooled
Volume
cu. ft (cu. m.)
Cooling Cap
BTU/hour
Electricity
120V Amps
Compressor
Motor
Shipping
Weight
18” 26” 31”
30032RSB 32” - 2 - 4 7.3 (0.21) 1550 8 1/3 H.P.
325 lbs
(147 kg)
30036RSB 36” - 2 - 4 7.3 (0.21) 1550 8 1/3 H.P.
325 lbs
(147 kg)
30048RSB 48” - - 2 4 10 (0.28) 1775 8 1/3 H.P.
400 lbs
(181 kg)
30060RSB 60” 2 2 - 6 13 (0.37) 1875 8 1/3 H.P.
530 lbs
(240 kg)
30064RSB 64” 2 2 - 6 13 (0.37) 1875 8 1/3 H.P.
530 lbs
(240 kg)
30072RSB 72” - 2 2 8 16 (0.45) 1920 10.1 1/2 H.P.
637 lbs
(289 kg)
30084RSB 84” 4 2 - 8 19 (0.54) 1955 10.1 1/2 H.P.
735 lbs
(333 kg)
30096RSB 96” - 6 - 12 23 (0.51) 1955 20 1/2 H.P.
835 lbs
(379 kg)
30108RSB 108” - 2 4 12 26 (0.74) 2000 20 1/2 H.P.
940 lbs
(426 kg)
Amperage is approximate and is for compressor only. Do not use for breaker sizing.