Manualshelf

Ultimate Range Series User Manual

ManualsBrandsSouthbend ManualsCommercial Cooking EquipmentUltimate Range Series 36" Gas Range with Four Standard Non-Clog Burners, One Manual Griddle, and Standard Cast Iron Grates, Up to 150000 BTUs (NG)/114000 BTUs (LP), Cabinet Base
12345678910
ULTIMATE RESTAURANT RANGES
OWNER’S MANUAL 1190820 REV 4 (10/14)
PAGE
8
OF 34
A set of four casters is packed with ranges ordered with casters (instead of legs).
A threaded leg pad is fastened to the base frame at each corner. Each caster has a corresponding mating thread. The
casters can be adjusted to overcome a slightly uneven oor. Casters are provided with a tting for proper lubrication
when required.
1. Raise range sufciently to allow the casters to be attached. For safety, “shore up” and support the range with an
adequate blocking arrangement strong enough to support the load.
2. Screw the casters into the holes in the centers of the leg pads. Install the casters that have a locking brake under the
front of the range.
3. Lower range gently onto a level surface. Never drop or allow the range to fall.
4. Use a level to make sure that the range surface is level. The casters can be screwed in or out slightly to lower or
raise each corner of the range.
5. Go to Installation Step 3
INSTALLATION
STEP 2C: ATTACH RESTRAINT
NOTICE
For an appliance equipped with casters, (1) the installation shall be made with a connector that complies with the
Standard for Connectors for Movable Gas Appliances, ANSI Z21.69 or Connectors for Movable Gas Appliances, CAN/
CGA-6.16, and a quick-disconnect device that complies with the Standard for Quick-Disconnect Devices for Use With
Gas Fuel, ANSI Z21.41, or Quick Disconnect Devices for Use with Gas Fuel, CAN1-6.9, (2) adequate means must be
provided to limit the movement of the appliance without depending on the connector and the quick-disconnect device
or its associated piping to limit the appliance movement, and (3) the restraining means should be attached to a frame
member on the back of the unit.
Installation of Casters
Figure 3
1. Secure the restraining-device bracket (item “B” in the following illustration) to a wall stud located as close as possible
to the appliance connector inlet and outlet connections. Use four #12 screws (items “C”) and plastic anchors (items
“A”) if necessary.