Manual

GAS CONVECTION OVENS
OPERATOR’S MANUAL 1181887 REV 9 (10/14)
PAGE
15
OF 44
NOTICE
Installation must use approved CSA International down draft diverter supplied by Southbend.
If the oven ue is to be connected directly to an external vent, a down draft diverter must be installed. The installation
of ventilation pipes through walls and roofs must conform to all local codes. To install the down draft diverter, do the
following:
1. Slip the down draft diverter over the top of the ue located at the top left rear corner of the oven (see drawing below).
Allow the diverter to slide down as far as it will go.
2. Using a 9/64” or 5/32” drill bit, drill eight holes through the ue box using the pre-drilled holes in the diverter as a
guide.
3. Secure the diverter to the ue box using the #10 x 1/2 sheet metal screws shipped with the diverter.
Installation of Down Draft Diverter
INSTALLATION
Figure 6
STEP 5: INSTALL DOWN DRAFT DIVERTER (IF APPLICABLE)