Instruction Manual

PLATINUM SERIES RANGE

OWNER’S MANUAL 1185836 REV 8 (9/14)

PAGE

OF 47

STEP 5: ATTACH FLUE RISER AND SHELF ASSEMBLIES

Install the ue riser(s) using the following procedure (as shown in Figure 16).

1. Attach any salamander broilers and ue-riser-mounted cheese melters to appropriate sections following the

installation procedure in the manuals for those options.

2. Slide each ue riser down onto the brackets projecting from the back of the corresponding section(s) of the

sectional range. Secure the ue riser to the brackets with the four provided 1/4-20x3/4 hex-head bolts, at washers,

and lockwashers. Also, secure the bottom edge of the ue riser to the top rear edge of the sectional range using the

provided #10 sheet metal screws.

3. If access to the interior of the ue riser is necessary to make gas connections, make those connections at this time.

Installation of Flue Riser

Figure 16

Slide the front of the flue riser down into

the brackets on the sectional range.

Secure the flue riser to the

brackets using the provided

fasteners. Also secure the

bottom edge of the flue riser

to the top rear edge of the

sectional range.

Attach the rear of the flue riser

to the front of the flue riser

using the provided fasteners.

INSTALLATION