Manual

-12-
For Machines Mfg. Since 8/09
Model SB1018
PREPARATION
The items listed below are optional components
and are not required for bandsaw operations.
Their installation and use is covered in
Operation, beginning on Page 20.
Description Qty
P. Work Stop Assembly ...................................... 1
Q. Chip Deflector ................................................ 1
Figure 7. Optional components.
Q
P
Figure 6. Additional stand components.
O
N
M
D
L
Not Shown Qty
• Hex Wrench 4mm .......................................... 1
• HexBoltM8-1.25 x 15 ................................. 12
• HexNutM8-1.25 .......................................... 18
• Flat Washer 8mm ........................................30
• FlatHeadScrewsM8-1.25 x 15 .................... 2
• HexBoltM12-1.75 x 25 ................................ 4
• Flat Washer 12mm ........................................4
• HexBoltM8-1.25 x 40 ................................... 4
• KnobM6-1x15 ..............................................1
• CotterPins .....................................................2
Figure 5. Stand components.
K
I
J
Description (Figure 5) Qty
I. Chip Tray ........................................................1
J. Rear Panel ...................................................... 1
K. Front Panel ..................................................... 1
Description (Figure 6) Qty
L. Left Panel ....................................................... 1
M. Right Panel .....................................................1
N. Bottom Shelf ...................................................1
O. Shelf ................................................................ 1