Instructions / Assembly

Page |
13
Figure 15
Attach Brackets (W) to Back Panel using
Screws (W). Tighten Screws (W) using a
Philips screwdriver.
Mark two desired locations on wall, same
distance as Brackets (W) on back of unit. Drill
two 3/16" holes on wall. Insert Plastic
Anchors (W) into holes on wall. (Use hammer
to help.)
Attach Brackets (W) to wall using Screws
(W). Tighten using a Philips screwdriver.
Move this item close to wall Brackets (W) and
tie in both Brackets (W) with Plastic Straps
(W) as shown.
Anti-tipping hardware must be used
for this product to avoid tipping and
injury.
Figure 16
Now your Dunston Bar Cabinet is ready to
use!
W