Use and Care Manual

Assembly (Continued)

• Save all instructions

If you need assistance or find any parts missing, CALL

TOLL FREE: 1-800-737-2112.

INSTALL THE OUTSIDE TINE SHIELDS (See Figure 8)

1. Each outside tine shield can be installed on

either side of the main tine shield.

2. Place the outside tine shield underneath the

main tine shield and align the holes.

3. Secure each outside tine shield to the main tine

shield with (3) M6 x 16 bolts washers and

lock nuts.

INSTALL LOWER HANDLE (See Figure 5)

1. Orient lower handle with upper square holes as

shown. Align lower handle holes with respective

holes in the frame and loosely install two M10 x

25 mm bolts, lock washers and flat washers on

each side.

2. Using a wrench, tighten bolts securely on

each side.

ATTACH UPPER HANDLE (See Figure 6,7)

1. Slide the upper handle down over the lower

handle and align the holes. Orient upper

handle so clutch lever is below handle.

2. Insert the saddle bolts into the holes as shown

and secure with at washers and handle knobs.

3. Tighten the handle knobs securely.

4. Using one cable tie, secure the control cable to

the handle as shown.

Figure 5

Figure 2

Figure 8

Figure 6

Figure 7