User's Manual

2. Rotate the hook to the other side
Changing colour covers (Fig. 6: Changing colour covers)
Your headset comes with four interchangeable colour covers to suit your style. To change a colour cover, hold it with
thumb and index and pull it out gently. Fit the new colour cover by gently sliding it in.
4. General Usage
Turning the Headset on
Press and hold the Multi-function Dial [1] for about 2 seconds until an audio tone is heard.
The Headset Indicator Light
[2]
will flicker green for approximately one second and will start flashing.
Turning the Headset off
Press and hold the Multi-function Dial [1] for about 2 seconds until an audio tone is heard.
The Headset Indicator Light will flicker red for approximately one second and the headset will switch off.
Receiving/answering a call
When the phone rings (ring tone can be heard in Headset), press the Multi-function Dial [1] briefly to answer the call.
Ending a call
Press the Multi-function Dial [1] briefly during a call and the call will be ended. The Headset is now ready to receive or
initiate another call.
Auto-sleep
To conserve battery life, your Headset features an auto-sleep function. This function switches the Headset off after 4
hours of inaction. Once your Headset has entered auto-sleep, it can be turned on again normally.
Changing Volume
The Headset will remember all volume settings even when it is switched off. The method of changing these settings is
described below.
To increase the volume, rotate the Multi-function Dial
[1]
forward.
To decrease the volume, rotate the Multi-function Dial [1] backward.
Making a call
A call can be initiated by the mobile phone or with the Headset itself (depending on the capabilities of your mobile
phone).
Initiating a call from your mobile phone
1. Ensure your Headset is switched on.
2. Ensure that your mobile phone has been correctly paired to your Headset and that the Bluetooth mode has been
enabled.
3. Make a call as usual with your phone. Your phone will transfer the call to your Headset.
Voice dialling from your Headset
Depending on your mobile phone, you may be able to initiate phone calls from your Headset (your phone will need to
support voice dialling).
To activate the voice dialling, briefly press the Multi-function Dial [1] on the Headset. If supported, you will hear a series
of tones and then be able to speak the name of the person you wish to call, resulting in the call being initiated.
Battery Level Indicator
You can check at any time the battery level. With the Headset turned on, if you press the Multi-function Dial [1] four
times, you will repeatedly hear a battery level indication:
o Four tones for a remaining talk-time above four hours.
o Three tones for a remaining talk-time around three hours.
o Two tones for a remaining talk-time around two hours.