Instructions / Assembly

1 - CHUCK IT UP 2 - ATTACH JET LINE 3 - PULL THE WIRE
4 - REMOVE FROM DRILL CHUCK 5 - LOOSEN THUMB SCREW 6 - REMOVE SLEEVE
7 - REMOVE JET LINE 8 - ALIGN SLEEVE 9 - ATTACH DRIVE CAP
Place wire pulling device in drive chuck
and tighten. Use “high torque/low
speed” and “drill setting” on drill if
available. Must use 18 Volt drill.
Loosen drill chuck and remove wire
pulling tool.
Grab pull string and twist in opposite
direction of original wire pull. String
will then slide off of the wire pulling
sleeve.
Replace sleeve back on wire pulling
tool making sure to align notches in
sleeve with drive pins on the wire
pulling main shaft.
Replace drive cap on wire pulling tool
making sure to align drive pins with
the notches in sleeve. Re-tigthen
thumb screw by hand.
Loosen thumb screw on drive cap
about 1 turn & slide drive cap off.
Remove sleeve with pull string from
wire pulling tool.
Tie a knot in the jet line. Wrap it
around the top of the sleeve once, and
position the knot in the knot recess in
the drive cap.
Slowly pull the trigger and begin to
pull wire. Tilt the tool back and forth
as you are pulling wire to form an
even string bundle across the sleeve
as seen in figure 3A.
3a
R
o
t
a
t
i
o
n
DO NOT USE FROM LADDER • ONLY USE WITH BOTH FEET ON THE GROUND • DO NOT ENGAGE OR USE TRIGGER LOCK
POWER PULL-IT INSTRUCTIONS FOR USE
Madison Electric Products, Inc. 26401 Fargo Avenue • Bedford Heights, OH 44146 • P: 1-800-631-7775 • F: 1-216-391-7912 © 2016/02146