SOWO - P10 User Manual SOWO Bluetooth speaker FCC ID: 2APCPP10PWL1903 Model Name: SOWO-P10 Portable 360°Sound Bluetooth Speaker Specifications Model : SOWO-P10 Bluetooth Version ： V5.0 Impedance ： 8Ω SNR : >75dB Charging ： DC 5V/1A Battery ： 3.
Aux in ： 3.5mm Wight ： 0.935lb（424g） Size ： 0.4X0.4X0.2ft Introduction Thank you for purchasing the SOWO Bluetooth speaker. This product is designed to provide high-quality music for your iPad, iPhone, iPod, computer, PDA, Android, and other smartphones. This instruction booklet explains the basic operation and care of the unit. Please read them carefully and keep for future reference. Maintenance Place the speaker on a level surface away from sources of direct sunlight or excessive heat.
Long press: Next song 3.short press: volume Long press: Previous song 4.TWS button Short press: TWS Pairing Long press: Clear TWS 5.Short press: Answer/Hang up, Switch the Bluetooth mode, re-connect the last Paired device Long press: Disconnect the current Bluetooth connection, Reject call 6.microphone Included Sound box , Micro USB Cable, 3.
Bluetooth Music Playing Please turn on the mobile phone or other devices music player, the speaker will play the selected music.
4) Now turn on Bluetooth on your phone or device. And start to search for Bluetooth devices, the “SOWO-P10” will be found, please connect it. If you want to connect PC or other devices with Audio via Aux Cable, please choose the master unit. 5) Once TWS connected, it will re-connect automatically when next power on, otherwise you can clear TWS by long press ” ” button. Playing Audio via Aux Cable Use the 3.5mm audio cable included to connect the speaker to an audio source (PC, MP3/MP4, mobile phone).
Charging the Unit When speaker with low battery capacity, the speaker will prompt “out of battery”, Please charge the battery via a USB adaptor immediately. During charging, the “ ” , “+”,”-” will flash slowly together, when fully charged, these buttons are on steadily. Note: Please use the good quality adaptor at 5V 1A, And it will cost for around 3~4 hours for the full charging. If adaptor with 5V 500 mA only, it will cost longer time for the full charging.
1) Check if any of speakers is connected with any device, the 2 speakers cannot be TWS paired if any of them is Bluetooth connected. 2) If these two P10 speakers paired with a third P10 speaker before.You need to remove the pairing memory first.Under Bluetooth mode without any connection ,please long press ” ” button of both speakers to remove previous pairing memory. 3) TWS pairing range is max.16ft, make sure two speakers are placed close enough.
IMPORTANT SAFETY INSTRUCTIONS When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However, improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully before installation and use, and keep these instructions handy for future reference. Take special note of all warnings listed in these instructions and on the unit. 1) Water and Moisture — The unit should not be used near water.
B. objects have fallen into or liquid has been spilled into the enclosure. C. the unit has been exposed to rain D. the unit has been dropped or the enclosure damaged E. the unit exhibits a marked change in performance or does not operate normally. 11) Periods of Nonuse - If the unit is to be left unused for an extended period of time, such as a month or longer, the power cable should be unplugged from the unit to prevent damage or corrosion.
FCC Caution. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
