Installation Instructions

ManualsBrandsSOYAL ManualsElectronicsSmart Digital Door Lock

SOYAL

ACCESS CONTROL SYSTEM

AR-323-D

V200615

Smart Digital Door Lock

RF Card

- 8 -

Mode

M4/M6/M8

Function

Enable the security trigger signal ( with AR-721RB)

Description

Change the "Arming" (in ) to the security trigger signal,

when controller is connected with AR-721RB.

Please refer to function default value for details.

Command

34 DDD

Function Selection Value Application

※

Default Value

Enable the RF after door sensor closed to GND

Invalid card to activate alarm relay

Turn o󰀨 all sounds of beeper

Mute the sounds of egress button (RTE)

Reserved

Keep beeing while arming is enabled

Door relay connected to AR-721RB (suited to models without relay built-in)

Arm relay connected to AR-721RB (suited to models with relay built-in)

※

0: Deactivate

※

0: Deactivate

※

0: Deactivate

※

0: Deactivate

※

0: Deactivate

※

0: Deactivate

※

0: Deactivate

※

0: Deactivate

Networking/Standalone

001

002

003

004

016

032

064

128

1: Activate

323DMaster

Test

MASTER CARD Setting

Use the MASTER CARD software

Input the MASTER CARD number, and press [Write].

Cut o󰀨 and tranmit the power. Activate master

the card number.

Present the card, and the reader will ash green

light 3 times and sound 3 beeps. Then the

card becomes MASTER CARD and accesses

programming mode.If MASTER CARD is presented

again, it will exit programming mode.

About Master Card / Master Card

Adding Tag Deleting All Tags

Present Master Card

P.S. Once MASTER CARD is presented after one

warning beep, all card data will be cleared.

After 3 short beeps

[Access programming mode]

After 3 short beeps

[Access programming mode]

Present one new card at a time

1 long warning beep after 2sec.

Present Master Card

[Exit programming mode]

5 short beeps after 5sec: cards cleared